Tell us about your application, and a PAVE engineer will get back to you with a rapid-turnaround quote. Whether you have a fully defined spec or are early in the design process, we can help.
PAVE-Seal® feedthroughs have fixed wire leads sealed permanently through the bulkhead with no disconnect. PAVE-Mate® connectors add a mating plug on one or both sides so you can disconnect without disturbing the seal. Use PAVE-Seal® for a permanent passthrough; use PAVE-Mate® when you need repeated connect/disconnect access.
The standard factory test is 80 psi nitrogen with no visible bubble. High-vacuum helium testing to 10⁻⁸ cc/sec is standard on vacuum-rated designs. Helium mass spectrometer testing to 4 x 10⁻¹⁰ cc/sec is available on request.
Standard designs are factory-tested to 80 psi. Most designs can be tested to several hundred psi on request, and select configurations are rated to 10,000+ psi. Vacuum ratings reach 10⁻⁸ Torr for UHV applications.
Yes. PAVE’s proprietary epoxy seals through virtually any insulation, including PTFE, ETFE, PVC, polyimide (Kapton), silicone, and rubber. If you have a non-standard wire, submit your spec and a PAVE engineer will confirm compatibility.
In-stock Quick Ship designs typically ship within 2 to 4 weeks from receipt of a valid purchase order. Call +1 (937) 890-1100 x102 to place an order by phone. Credit cards accepted.
Call +1 (937) 890-1100 x103 or submit your spec online. A PAVE engineer will review your application and recommend the right solution at no charge.
Trusted By:
